Data Sheet

05 Dec 2013
© 2013 Communication Networks. All Rights Reserved. “ComNet,” the “ComNet Logo,” “NetWave” and the “NetWave Logo” are registered trademarks of Communication Networks.
3 CORPORATE DRIVE
|
DANBURY, CONNECTICUT 06810
|
USA
|
T: 203.796.5300
|
F: 203.796.5303
|
TECH SUPPORT: 1.888.678.9427
|
[e-mail]
8 TURNBERRY PARK ROAD
|
GILDERSOME
|
MORLEY
|
LEEDS, UK LS27 7LE
|
T: [phone]
|
F: [phone]
|
[e-mail]
CNGE2MC[M] & CNGE22MC
10/100/1000 Mbps Ethernet Media Converters
SPECIFICATIONS
Data
Data Interface Ethernet
Data Rate 10/100/1000 Mbps
IEEE 802.3 Compliant
Full Duplex or Half Duplex Electrical Port/Full
Duplex Optical Port
Fibers SFP Dependent
Fiber Connectors¹ Requires selection of sold-separately SFP modules.
See ComNet data sheet for number and description
of SFP modules
Connectors
Power Terminal Block
Electrical RJ45
Indicating LEDs - Optical Link/Data Activity
- Power
Power
Operating Voltage Range CNGE2MC[M]: 8–15 VDC
CNGE22MC: 8–15 VDC
Power Consumption CNGE2MC[M]: 6W CNGE22MC: 11W
Electrical & Mechanical
Current Protection Automatic Resettable Solid-State Current Limiters
Circuit Board Meets IPC Standard
Size ComFit: 6.1 × 5.3 × 1.1 in (15.5 × 13.5 × 2.8 cm)
Small Size: 3.3 x 2.5 x 1.1 in. (8.4 x 6.4 x 2.8 cm)
Shipping Weight <2 lbs./0.9 kg
Environmental
MTBF >100,000 hours
Operating Temp -40˚ C to +75˚ C
Storage Temp -40˚ C to +85˚ C
Relative Humidity 0% to 95% (non-condensing)²
[1] Multimode fiber needs to meet or exceed fiber standard ITU-T
G.651. Single mode fiber needs to meet or exceed fiber standard
ITU-T G.652
ORDERING INFORMATION
Part Number Description
CNGE2MC 2 Port (1 Channel) 10/100/1000 Mbps Ethernet Media Converter
CNGE2MCM Small Size 2 Port (1 Channel) 10/100/1000 Mbps Ethernet Media Converter
CNGE22MC 4 Port (2 Channel) 10/100/1000 Mbps Ethernet Media Converter
Included DC Plug-in Power Supply, 90-264 VAC, 50–60 Hz (Included)
Options [2] Add suffix ‘/C’ for Conformally Coated Circuit Boards to extend to condensation conditions (Extra charge, consult factory)
DIN-Rail Mounting Adaptor Plate Kit - With Mounting Hardware (Optional, order model DINBKT1)
NOTE: This product requires a fiber installation with a minimum 30 dB connector return loss. The use of Super Polish Connectors is recommended.
Complies with FDA Performance Standard for Laser Products, Title 21, Code of Federal Regulations, Subchapter J. In a continuing effort to improve
and advance technology, product specifications are subject to change without notice.
TYPICAL APPLICATION
CNGE2MC
w/ SFP-6
CNGE2MC
w/ SFP-6
E E
OPTICAL FIBER
CAT5
LEGEND