Quick Start Guide

QSG_CNGE11FX3TX8MS[POE][HO]_REV– Rev. 9.20.16 PAGE 8
QUICK START GUIDE CNGE11FX3TX8MS[POE][HO]
TECH SUPPORT: 1.888.678.9427
Front Panel LEDs
LED Color Status Description
Power Green On System power connected correctly
Alarm Red On Alarm Fault Status has been triggered
Power 1 Alarm Green On Power lost to VIN1 terminal block
Power 2 Alarm Green On Power lost to VIN2 terminal block
PoE (Power over Ethernet)
30W A Green On MODE A PoE is being supplied on indicated RJ-45 port
30W B Green On MODE B PoE is being supplied on indicated RJ-45 port
Gigabit Ethernet ports
LNK/ACT Green Blinking Data transmitted.
Full Duplex Amber On Port in Full Duplex mode
Gigabit SFP ports
Link/Activity Green
Blinking Data transmitted.
On Port link up.
WEB Management
Attention: While installing and upgrading firmware, please remove physical loop connection first.
DO NOT power off equipment while the firmware is upgrading!
Configuration by Web Browser
About Web-based Management
An embedded HTML web site resides in the flash memory on the CPU board. It contains
advanced management features and allows you to manage the switch from anywhere on the
network through a standard web browser such as Microsoft Internet Explorer.
The Web-Based Management function supports Internet Explorer 5.0 or later. It is based on Java
Applets with an aim to reduce network bandwidth consumption, enhance access speed and
present an easy viewing screen.
Note: By default, IE5.0 or later version does not allow Java Applets to open sockets. You need to
explicitly modify the browser setting in order to enable Java Applets to use network ports.
Preparing for Web Management
The default value is as below:
IP Address: 192.168.10.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.10.254
User Name: admin