Data Sheet

21 Mar 2016
© 2016 Communication Networks. All Rights Reserved. “ComNet” and the “ComNet Logo” are registered trademarks of Communication Networks.
3 CORPORATE DRIVE
|
DANBURY, CONNECTICUT 06810
|
USA
|
T: 203.796.5300
|
F: 203.796.5303
|
TECH SUPPORT: 1.888.678.9427
|
[e-mail]
8 TURNBERRY PARK ROAD
|
GILDERSOME
|
MORLEY
|
LEEDS, UK LS27 7LE
|
T: [phone]
|
F: [phone]
|
[e-mail]
Data
Data Interface Ethernet
Data Rate 10/100 Mbps
IEEE 802.3 Compliant
Full Duplex or Half Duplex Electrical Port/Full
Duplex Optical Port
Fibers¹ SFP Dependent
Connectors
Optical Requires selection of sold-separately SFP
modules. See ComNet data sheet for number
and description of SFP modules
Power Terminal Block
Electrical RJ45
PoE pin assignment RJ45 port #1 supports IEEE802.3at
End-point Positive (VCC+): RJ45 pin 1, 2
Negative (VCC-): RJ45 pin 3, 6
Data (1, 2, 3, 6)
Max. PoE current 600mA continuous
LED Indicators Optical Link/Data Activity, Power, PSE
Electrical & Mechanical
Power 12VDC @ 3A, 24VDC@1.5A
Current Protection Automatic Resettable
Solid-State Current Limiters
Circuit Board Meets IPC Standard
Size ComFit 6.1 × 5.3 × 1.1 in (15.5 × 13.5 × 2.8 cm)
Mini: 4.1 × 3.7 × 1.1 in (10.4 × 9.4 × 2.8 cm)
Shipping Weight <2 lb / 0.9 kg
Environmental
MTBF >100,000 hours
Operating Temp -40° C to +75° C
Storage Temp -40° C to +85° C
Relative Humidity 5% to 95%²
[1] Multimode fiber needs to meet or exceed fiber standard
ITU-T G.651. Single mode fiber needs to meet or exceed
fiber standard ITU-T G.652
CNFE2MCPOE[2,/M]
10/100 Mbps Ethernet media converter
Electrical to SFP Optical with Power over Ethernet
SPECIFICATIONS
A
GENCY COMPLIANCE
ORDERING INFORMATION
Part Number Description
CNFE2MCPOE ComFit 10/100 Mbps Ethernet Media Converter with PoE
CNFE2MCPOE2 ComFit 10/100 Mbps Ethernet Media Converter with PoE, and 2 DIP switch operation (POE and Fiber Link control)
CNFE2MCPOE/M Mini 10/100 Mbps Ethernet Media Conveter with PoE
Included Accessories 24 Volt DC 1.5 Amp Plug-in Power Supply, 90-264 VAC, 50/60 Hz (Included, for benign 0º to 50ºC applications only. Hardened power supply available,
consult factory)
Options [2] Add suffix ‘/C’ for Conformally Coated Circuit Boards to extend to condensation conditions (Extra charge, consult factory)
NOTE: This product requires a fiber installation with a minimum 30 dB connector return loss. The use of Super Polish Connectors is recommended.
Complies with FDA Performance Standard for Laser Products, Title 21, Code of Federal Regulations, Subchapter J
In a continuing effort to improve and advance technology, product specifications are subject to change without notice.