Data Sheet

LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427

FEATURES

› Support 100M/1G/10G optical bypass function of 2 port duplex or 4 port simplex

fiber connection

› Different models supported for multi-mode or single-mode optical fiber

› Low insertions loss

› Throughput not affected and no extra delay

› Bypass switching time < 10ms

› Dual wide-range power inputs: 12~48VDC

› Relay output for power failure warning

› Rigid IP-30 housing design

› Surface, Wall or DIN-Rail tmount form factor

› Lifetime Warranty

The ComNet CN-OB(M,S) external bypass switches for 100M/1G/10G fiber optic

networks protect the network from failures and ensure network integrity during power

loss. Each of these fiber optical bypass switches includes Network ports and Monitor

ports. The Network ports are used for connection to main-network connections and

provide protection mechanism, and the Monitor ports are used for down-link local

networking device. When the power is on, the operation mode of the Bypass switch is

set to Normal, and the local networking device is connected with main-network. When

power failure occurs, the Bypass switch is swiftly set to bypass mode to isolate the main-

network from the local networking device.

CN-OB(M,S)

Industrial 2-Port Optical Bypass Switch

with 4 × LC Duplex Connectors

2 DUPLEX 2 DUPLEX

-20 TO

70ºC

DIN RAILREDUNDANT

PAGE 1
Industrial 2-Port Optical Bypass Switch with 4 × LC Duplex Connectors CN-OB(M,S) REDUNDANT DIN RAIL -20 TO +70ºC 2 DUPLEX 2 DUPLEX The ComNet CN-OB(M,S) external bypass switches for 100M/1G/10G fiber optic networks protect the network from failures and ensure network integrity during power loss. Each of these fiber optical bypass switches includes Network ports and Monitor ports.
PAGE 2
Industrial 2-Port Optical Bypass Switch with 4 × LC Duplex Connectors CN-OB(M,S) SPECIFICATIONS Fiber Optic Electrical & Mechanical Optical Ports 4 Duplex LC connectors Fiber Single mode 9/125μm 1260 ~ 1570 nm or Multimode 50/125μm or 62.5/125μm 780 ~ 1350 nm (model dependent) Insert Loss 1.6 dB (Single mode) or <1.