Data Sheet

LIFETIME WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
CLRFE1EOC(P,E)/M
Mini Ethernet-over-Coax Extender Remote Units
Powered by External or PoE Source
SPECIFICATIONS
Ethernet
Data Interface 10/100BaseT(X) Ethernet
Data Rate DIP switch selection of 10/100 Mbps
Full data rate / full duplex up to the maximum
rated distance
RFC 2544 TCP/IP Packet Transmission
Standards IEEE 802.3af PoE (CLRFE1EOCP/M),
RFC: 768 UDP, 2068 HTTP, 793 TCP
791 IP, 1783 TFTP, 894 IP over Ethernet.
Transmission Distances
1
See chart below
Connectors
Ethernet RJ-45
Extended Distance Pigtailed BNC
Operating Power CLRFE1EOCP/M: Powered by PoE
CLRFE1EOCE/M: 2-pin screw terminal
LED Indicators Operating Power
Ethernet Link and Activity
Extended Link and Activity
Power
CLRFE1EOCP/M Runs off PoE pass-through only
CLRFE1EOCE/M 12 VDC or 24 VAC
Power Consumption 1.5 W
Mechanical
Current Protection Automatic Resettable Solid-State Current Limiters
Circuit Board Meets IPC Standard
Size (L×W×H) 2.3 × 1.6 × 1.1 in (5.7 × 4.1 × 2.8 cm)
Shipping Weight <1 lbs./0.45 kg
Environmental
MTBF >100,000 hours
Operating Temp – 40˚ C to +75˚ C
UL Safety certifications conducted at maximum
ambient temperatures (T
ma
) of 65ºC.
Storage Temp – 40˚ C to +80˚ C
Relative Humidity 0% to 95% (non-condensing)
2
MAXIMUM TRANSMISSION DISTANCES
1
Media COAX - RG59/U
Data Rate
10M 100M
Source Power
15W 30W 15W 30W
Non-PoE Max.Distance
1
5,000 ft
1,524 m
2,000 ft
610 m
PoE CLASS2 (6.5W)
1
3,000 ft
914 m
3,000 ft
914 m
2,000 ft
610 m
2,000 ft
610 m
PoE CLASS3 (13W)
1
750 ft
228 m
850 ft
259 m
750 ft
228 m
850 ft
259 m
[1] Distance figures are based on a 50 V PSE PoE power source, and external power supplies for the extenders. Distance figures are obtained using in-house testing mirroring installations. Factors such
as coaxial cable quality, the number of connectors and splices in the cable run, the use of PoE, and environmental conditions encountered within the installation might affect the actual transmission
distance and should be taken into consideration. Due to advanced negotiation signaling required in IEEE802.3at applications, pass-through applications are limited to IEEE802.3af PD devices only.