Data Sheet

SPECIFICATIONS
ORDERING INFORMATION
INSTALLATION & OPERATION
TYPICAL APPLICATION
Interface
Type 100BaseTX
Connector SFP / MSA Compliant
Connectors RJ-45
Data Rate 10 or 100 Mbps
Mechanical
Operating Voltage 3.3 V
Power Consumption 1 W Max
Dimensions (H x W x L) 0.48 × 0.55 × 2.91 in (12.4 × 14.0 × 74.1 mm)
Weight 1.06 oz (30.0 g)
Environmental
Operating Temp -40°C to +75°C
Storage Temp -40°C to +85°C
Relative Humidity 0 to 90%, non-condensing
Part Number Description
CL-SFP1 10 Mbps Copper Range Extending SFP
CL-SFP3 100 Mbps Copper Range Extending SFP
CLRJ2COAX Adapter for RJ-45 to COAX
CLRJ2COAXCAB Adapter Cable for RJ-45 to Coax
CLESP Single Port Ethernet Surge Protector
Optional Accessories RJ-45 Breakout Wiring Kit (Includes cable and terminal block)
CL-SFP is a book-end solution that can work only with an additional CL-SFP or
ComNet™ CopperLine® unit.
Follow the instructions below to install and connect CL-SFP:
Plug one of the two CL-SFP into the 100BASE-FX SFP slot of a device/switch. Repeat
this step for the second CL-SFP in the pair.
Connection
Connect CL-SFP devices using a twisted 2-wire cable (use pins 1 & 2) or Coax
Always connect CL-SFP to another CL-SFP device or a ComNet™ CopperLine® unit. If an
CL-SFP was connected to a regular port of any Ethernet device, such as a switch, reset
the CL-SFP by unplugging and re-inserting the unit.
Link synchronization may take up to one minute.
LED Indicators Use 100BaseTX LED on the host
CL-SFP
CL-SFP CL-SFP
Network Switch Network Switch
UTP/Coax
Extended Distance
UTP/Coax
Extended Distance
Install into
SFP Port
Install into
SFP Port
Small Form-Factor Pluggable
Copper Range Extender Module
CL-SFP
CopperLine
Extender
Network Switch Network Switch
Install into
SFP Port
Distance figures are obtained using in-house testing mirroring
installations. Factors such as coaxial and copper cable quality, the
number of connectors and splices in the cable run, and environmental
conditions encountered within the installation might affect the actual
transmission distance and should be taken into consideration.
30 Mar 2015© 2015 Communication Networks. All Rights Reserved. “ComNet” and the “ComNet Logo” are registered trademarks of Communication Networks.
3 CORPORATE DRIVE
|
DANBURY, CONNECTICUT 06810
|
USA
|
T: 203.796.5300
|
F: 203.796.5303
|
TECH SUPPORT: 1.888.678.9427
|
[e-mail]
8 TURNBERRY PARK ROAD
|
GILDERSOME
|
MORLEY
|
LEEDS, UK LS27 7LE
|
T: [phone]
|
F: [phone]
|
[e-mail]