Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation

Document PN 29010078 V2.0 - 1 -

DRAFT #3 – 29 May 2009

Welcome

Congratulations on your purchase of a ComNav Marine Vector G2 or Vector G2B GPS

Compass! At ComNav, we are dedicated to reliability & quality in all our products, and the

Vectors are a good example of that. We promise to do our best to ensure your satisfaction

with your new Vector GPS Compass.

ComNav Marine Ltd.

Warranty Notice

Prior to the installation and/or operation of the equipment, ensure that you read, understand,

and accept the conditions of the warranties as detailed in the

Warranty Information section of

this manual.

General Notice

This document, ComNav part number 29010078 Version 2 Revision 0, is the approved

Installation and Operation Manual for use with Vector G2 & G2B GPS Compasses. Where

versions of this manual exist in other languages, the English version shall be considered

authoritative.

Special Note

This manual applies primarily to the third generation of the Vector G2 & G2Bs.

A Vector’s generation can be determined by the initial 4 digits of its serial number, which are

a “date code” identifying the year and week it was manufactured. The serial number is on the

label on the underside of the enclosure.

This third generation’s date codes are 0902, or later.

The second generation began at date code 0722 and finished at 0850. For that generation,

please refer to any of revisions 1.4 through 1.6 of this manual, and Addendum #1.

It should be noted that much of the information in this manual can

be used with the later half

of the second generation (date codes 0802 through 0850) – as long as some care is used,

since a few features of the second generation differ from the third generation’s. For details,

see page 89.

The first ge

ration had date codes of 0721 or earlier. For that generation, please refer to

revision 1.2 of this manual.