Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation Appendices
Document PN 29010078 V2.0 - 85 -
DRAFT #3 – 29 May 2009
6) Here is the G2’s reply when you enter a $JSAVE command:
(normal data output … whatever is currently configured)
...
...
$> Saving Configuration. Please Wait...
...
...
(normal data output continues for ~5 seconds)
...
...
$> Save Complete
...
...
(normal data output continues)
7) Here is a typical power-on sequence from Port A (configured with the ComNav factory
default settings):
Note: the time intervals shown here are more or less normal; in your
installation, they may be shorter or longer, depending on the G2’s
location, its sky view, current GPS signal reception conditions, and so on.
• the first several seconds are mostly all Null data. Also, GSV does not appear below
(it often does not start immediately, even though there may be many visible
satellites):
$GPHDT,,T*1B
$GPROT,,V*08
$GPHDM,,M*1B
$GPHDG,,,E,,E*70
$PSAT,HPR,,,,,*5C
$GPGGA,,,,,,0,,,,M,,M,,*66
$GPGLL,,,,,,V,N*64
$GPVTG,,T,,M,,N,,K,N*2C
$GPZDA,,,,,00,00*48
$GPHDT,,T*1B
$GPROT,,V*08
$GPHDM,,M*1B
$GPHDG,,,E,,E*70
$PSAT,HPR,,,,,*5C
$GPGGA,,,,,,0,,,,M,,M,,*66
$GPGLL,,,,,,V,N*64
$GPVTG,,T,,M,,N,,K,N*2C
$GPZDA,,,,,00,00*48
$GPHDT,,T*1B
$GPROT,,V*08
$GPHDM,,M*1B
$GPHDG,,,E,,E*70
$PSAT,HPR,,,,,*5C
$GPGGA,,,,,,0,,,,M,,M,,*66
$GPGLL,,,,,,V,N*64
$GPVTG,,T,,M,,N,,K,N*2C
$GPZDA,,,,,00,00*48
$GPHDT,,T*1B
$GPROT,,V*08
$GPHDM,,M*1B
$GPHDG,,,E,,E*70
$PSAT,HPR,,,,,*5C
$GPGGA,,,,,,0,,,,M,,M,,*66
$GPGLL,,,,,,V,N*64
$GPVTG,,T,,M,,N,,K,N*2C
$GPZDA,,,,,00,00*48
$GPHDT,,T*1B
$GPROT,,V*08
$GPHDM,,M*1B
$GPHDG,,,E,,E*70
$PSAT,HPR,,,,,*5C
$GPGGA,,,,,,0,,,,M,,M,,*66
$GPGLL,,,,,,V,N*64
$GPVTG,,T,,M,,N,,K,N*2C
$GPZDA,,,,,00,00*48
$GPRMC,,V,,,,,,,,,,N*53
$GPGSA,M,1,,,,,,,,,,,,,,,*12
$GPGST,,,,,,,,*57
www.busse-yachtshop.de | [e-mail]