Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation Appendices

Document PN 29010078 V2.0 - 74 -

DRAFT #3 – 29 May 2009

– Click on the ASCII Setup button:

Figure 27 – COM Port ASCII Setup Dialog Box

Note: you may find that a Line Delay longer or shorter than 10 msec

will be needed on your PC; you may also need to set a non-zero

Character Delay.

– The other buttons on the Settings Tab do not need to be clicked, since the

default parameter values on those dialogs are fine.

• Exit the File ⇒ Properties ⇒ Settings dialog (click on the appropriate OK buttons).

Save and Re-use the Connection

One you have finished setting up the New Connection(s) satisfactorily, you should do a

manual Save, so that you have it (them) stored for subsequent use: File ⇒ Save.

When you want to re-open a saved session: File ⇒ Open, then select the session you want.

Alternatively, you can use File ⇒ Save As to store the session(s) in some other folder on your

PC’s file system (HyperTerminal always stores New Connections in its own folder), and then

navigate back to that folder when you later do a File ⇒ Open.