Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation Appendices

Document PN 29010078 V2.0 - 73 -

DRAFT #3 – 29 May 2009

• The new connection’s communication session will then start – but HyperTerminal is

not fully set up yet for use with the G2, so click on the Disconnect button, to stop the

session:

Figure 24 – Disconnect Button Figure 25 – Call Button

• Set up the remaining COM port parameters; select File ⇒ Properties ⇒ Settings:

Figure 26 – COM Port Properties Dialog Box, Settings Tab