Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation Installation

Document PN 29010078 V2.0 - 23 -

DRAFT #3 – 29 May 2009

Pole Base

Figure 8 – Mounting using the Pole Base

1) Install a threaded mounting pole at the location you have chosen. The pole must be

supplied by you; it must have an appropriate height for the location, and must have

1-14-UNS threads on one or both ends. If you are mounting the pole on a surface,

drill & de-burr a hole in the surface, centered in the pole, with a diameter at least

slightly larger than the G2’s cable.

2) Fasten the pole securely to the vessel, using appropriate fasteners, clamps, etc. of

your choice; ComNav recommends that all hardware be corrosion-resistant.

3) Thread the supplied 1-14-UNS threaded hex jam nut, and then a suitable flat washer,

onto a 1-14-UNS threaded end of the mounting pole – the end which will be the top

end of the pole.

Figure 9 – Jam Nut and Washer