Operating Instructions and Installation Instructions

ComNav Vector G2 & G2B Installation & Operation Installation

Document PN 29010078 V2.0 - 20 -

DRAFT #3 – 29 May 2009

• If you wish, you can instead install the G2 perpendicular to the vessel’s fore-aft

centreline, i.e., on (or parallel to) the athwartships centreline. In this orientation, the

G2 can output both the Heading and the Roll of the vessel.

Vessel’s

Heading

Arrow on

case bottom

Short-sight

(side) Post

Alignment

Sight

Long-sight

(front) Post

Secondary

Antenna

Primary

Antenna

Figure 3 – Heading & Roll Installation (viewed from above)

Note: you must also reconfigure some of the G2’s configuration

parameters in this orientation (see Roll Alignment on page 58, and

the GPS Technical Refere

nce).

The figure shows the G2 pointing to the vessel’s Port; you could also

mount it pointing to Starboard.