Specifications

ComNav Explorer V1T and V1C Installation & Operation
Installation
Please refer to the Warranty Information section of this manual before proceeding with
installation of the Explorer V1T/V1C.
Tools Required
General-purpose tools such as a portable drill, pliers, wire cutters, screwdrivers, wire, mounting
bolts and wrenches may be required, as well as an accurate voltmeter or multi-meter.
Hazard warning
Extreme caution is advised when using tools powered by Mains supply
circuit (AC), regardless of whether those circuits are rated for “indoor”,
“outdoor”, “marine” or “industrial” use. Water, especially sea water, is an
excellent conductor of electricity. If AC tools are used, they must be
plugged into a circuit that is adequately protected against Ground Faults
and other safety hazards, and in accordance with local and national
electric codes. Failure to comply may result is severe injury or death.
Battery powered tools are STRONGLY recommended
Power Supply
For reliable operation of your Explorer V1 Camera System, your vessel’s power supply system
must have an adequate breaker circuit, or fused DC (direct current) power supply at a nominal
voltage of 12VDC. A power on/off switch is recommended.
Ensure that adequate wire size is used to handle the expected maximum currents.
Note: It is strongly recommended that the Explorer’s power wiring
be run directly from the power supply – especially for 12 Volt
systems. The minimum supply voltage is specified as 9 Volts, at the
camera connection point. If the voltage drops below 9 Volts, the
camera system may exhibit erratic behaviour, such as periodic
resetting.
Environmental Considerations
Ensure that the Explorer system Operating & Storage Temperature are within the acceptable
range (see Specifications, Mechanical, on page 32)
.
The Explorer camera components: case, cable & mount are waterproof – but they are not
submersible.
Joystick Unit and Controller Unit
Note: Please take care when choosing the location of
mounting the Joystick controller as it must be installed in the
proximity of the Camera Controller unit, within 3 meters.
Refer to the last page of the manual for a Joystick Mounting
Template. You may tear this page out to use for marking the
Document PN 29010088 V1.1 - 19 -