Specifications

ComNav Explorer V1T and V1C Installation & Operation Introduction
Preset Positions
(Not available with the basic style controller Joystick)
Up to 100 user defined camera positions can be stored in the cameras memory to be accessed individually or as part
of a tour or cruise. Pan, Tilt, and Zoom values are stored when presets are stored. Autofocus is default for preset
positions
.
NOTE: Certain presets are assigned to activate other
features such as patterns and image flip.
Auto Cruise
(Not available with the basic style controller Joystick)
Preset positions (up to 39) can be programmed into a tour. Once initiated, the camera will cruise through each preset
position. (Presets 1~39 are included in the tour). Preset #82 initiates Auto Cruise. There’s a 10 second dwell time
between each preset. Auto Cruise loops once the last preset in the tour is completed, starting back at preset 1.
Patterns
(Not available with the basic style controller Joystick)
Up to four patterns can be set, each controlling up to 10 preset positions. Patterns act like ‘mini-tours’. Once initiated,
the camera will move between preset positions in the pattern. Preset #84 starts pattern 1 (Preset #40 ~49), preset #85
starts pattern 2 (Preset #50~59), preset #86 starts pattern 3 (Preset #60~69), preset #87 starts pattern 4 (Preset
#70~99). There is no dwell time between each preset. The camera will sequence back down through the presets once
the last preset within the pattern is called
.
Explorer V1C – Low Light Camera
Proportional Pan and Tilt
Proportional pan automatically reduces or increases the pan and tilt speeds in proportion to the zoom level. At
telephoto zoom, the pan and tilt speeds will be slower for a given amount of joystick deflection then at wide zoom level.
This keeps the image from moving too fast on the monitor when there is a large amount of zoom.
Preset Positions
(Not available with the basic style controller Joystick)
Up to 100 user defined camera positions can be stored in the cameras memory to be accessed individually or as part
of a tour or cruise. Pan, Tilt, and Zoom values are stored when presets are stored. Autofocus is default for preset
positions
.
NOTE: Certain presets are assigned to activate other
features such as patterns and image flip.
Lens Control (Zoom, Focus, Iris)
ZOOM: Zoom Wide / Zoom Tele. Optical Zoom ratio 1 ~ 26. Digital Zoom x12 thereafter
FOCUS: Focus Near / Focus Far. By default system is auto-focus. After any manual changes to the focus, the camera
will default to auto focus following any pan, tilt or zoom command.
IRIS: Open / Close. By default system is auto-iris. After any manual changes to the iris, the camera will default to
auto iris following any pan, tilt or zoom command
.
Document PN 29010088 V1.1 - 15 -