Specifications

Configuring your Mariner X2
Page 15
4 Configuring your Mariner
X2
4.1 Switching on your Mariner X2 for
the first time
A few seconds after applying power to the Mariner X2 for the first
time all four indicators (green, amber, red and blue) will blink twice.
The indicator sequence following this will depend on whether your
transceiver is pre-configured.
Transceiver is pre-configured:
The amber indicator will illuminate until the transceiver has
transmitted an AIS message.
Transceiver is not pre-configured:
The amber and red indicator will illuminate. This indicates the unit
cannot transmit until it is configured with a valid MMSI.
Figure 13 Indicator start up sequence
Prior to use the Mariner X2 requires programming with the vessel's
static data to ensure that the data transmitted by the Mariner X2
matches that of the host vessel.
Indicator lights
Blue Red Amber Green
!
US Customers only: It is a violation of the rules of the
Federal Communications Commission for the end user
to programme the static data. The static data must only
be programmed by a competent installer. If your
Mariner X2 has not been preconfigured for you please
refer to your dealer for advice on how to have the
Mariner X2 configured by a competent installer.