Specifications

Installation
Page 9
3.2 Installation procedures
Before beginning installation of your Mariner X2, please ensure you
have the necessary additional items as detailed in section
3.1. It is
strongly recommended that you read all of the instructions in this
manual prior to installation.
If after reading this manual you are unsure about any element of the
installation process please contact your dealer for advice.
The following sections explain the installation process step by step
for each of the main elements of the system.
Step 1 - Installing the Mariner X2
Please note the following guidelines when selecting a location for
your Mariner X2:
• The Mariner X2 must be fitted in a location where it is at least
0.5m from a compass or any magnetic device.
• There should be adequate space around the Mariner X2 for
routing of cables. See
Figure 5 for details of the Mariner X2
dimensions.
• The ambient temperature around the Mariner X2 should be
maintained between -10°C and +55°C.
• The Mariner X2 should not be located in a flammable or
hazardous atmosphere such as in an engine room or near to fuel
tanks.
• The Mariner X2 is fully waterproof to ingress protection rating
IPx7, however it is recommended that the Mariner X2 is not
subjected to extended periods of exposure to spray or
submersion.
• It is recommended that the Mariner X2 is installed in a 'below
decks' environment.
• It is acceptable to mount the Mariner X2 either vertically or
horizontally.
• The product is supplied with four self tapping screws for
attachment of the Mariner X2 to a suitable surface. Please refer
to
Figure 6 for guidance.
• The Mariner X2 should be mounted in a location where the
indicators are readily visible as these provide important
information on the status of the Mariner X2.