Specifications

Installation
Page 7
3Installation
3.1 Preparing for Installation
Figure 4 shows a typical installation configuration for the Mariner
X2. Please take the time to familiarise yourself with the system
elements and their connections prior to attempting installation.
Figure 4 Typical installation configuration
In addition to the items provided with your Mariner X2 the following
items will be required for installation:
VHF antenna
Connection to a suitable VHF antenna will be required for the
Mariner X2 to operate. A standard marine band VHF antenna such
as that used with VHF voice radios will be sufficient. Please take
note of the warnings in section
1 regarding the use of antennas.
Alternatively, if you wish to use an existing VHF antenna, antenna
splitter products are available which allow the existing antenna to be
used with two radio devices, such as a VHF voice radio and the
Mariner X2.
Antenna cables
The GPS antenna is provided with 10 metres of cable. If this is not
sufficient to reach between the desired GPS antenna location and
the Mariner X2 unit you will need an extension cable. Please
contact your dealer for details. For reference the GPS antenna
connector type on the Mariner X2 unit is TNC receptacle, and is
intended to mate with a TNC jack connector.
Switch
Power in
RS232
GPS Antenna
Class B AIS transceiverChartplotter
VHF Antenna
!
When selecting an AIS antenna splitter make sure it is
capable of operation with an AIS transceiver. Some AIS
antenna splitters are designed to work only with AIS
receivers. Please check with your dealer to ensure you
purchase the correct type of antenna splitter.