User's Guide

SinoGNSS
○
R
T300 PLUS User Guide
21
4 Static survey
This chapter describes static survey through T300 PLUS receiver and CRU software. For
static survey, you cannot change settings through front panel, you can configure it via
Compass Receiver Utility (CRU): 1) Receiver configuration; 2) check receiver settings
and status; 3) convert data to Rinex format.
4.1 Receiver Configuration
1. Download and install CRU software from the link below (ensure the driver is
properly installed in your PC):
http://www.comnavtech.com/download.asp?bigclassid=28
2. Put a battery in the T300 PLUS receiver and turn it on.
2. Connect the receiver with your PC through serial port cable.
3. Click set port in CRU -> select proper serial port in the serial port option-> enter
proper baud rate -> click Ok to complete receiver connection.The SN of receiver will
appear in the title bar if connected successfully.
Tips:
1) F o r T300 PLUS receivers, USB cable is only used to do wnload raw observation data, cannot
to connect to CRU software and update firmware;
2) With 7-pin Lemo to RS232 cable, you can connect T300 PLUS receiver with external power
or firmware upgrade.
3) It can not to configure the static settings, only supports to configure using web UI.