User's Guide

SinoGNSS
○
R
T300 PLUS User Guide
18
b) Ntrip settings: Choose Ntrip version, set IP, port, username, password, mountpoint,
and choose data stream, supports RTCM3.2, RTCM3.2(MSM5), RTCM3.0, RTD, CMR.
Check on Use, and click Enter to apply, click Cancel to cancel apply; Check off Use, and
click Enter to cancel the previous base setup.
After you setup base using Ntrip server successfully, you can go to Device->Status to
check current base settings, and the rover can get the mountpoint from the server you
set.
(2) Radio:
a) You need to setup base station coordinate first, refer to the Ntrip Server settings.
b) Setup the radio parameters: The model is TX, set the frequency, minimum interval
is 12.5 KHz; the protocol is Transparent; set the power, supports 0.5w, 1w and 2w;
choose data stream, supports RTCM3.2, RTCM3.2(MSM5), RTCM3.0, RTD, CMR; check
on Use, click Enter to apply the internal radio; Check off Use, click Enter to cancel the
work mode.