User's Guide

SinoGNSS
○
R
N5 User Guide
28
http://www.hw-group.com/products/HWg-Ares/HWg-Ares_GSM_APN_en.html#top
5.8.1 Point to Point/Points mode (P to PS mode)
In point to point mode, the correction data is transmitted from the base station to
the server, then rovers can log on the server to get the correction data. Therefore,
SIM cards are required both in the Base and Rover.
Tip: ComNav technology provides a free static server address 211.144.120.104:8888, anyone can
upload CORS data as long as abide by the agreement.
Below shows Base configuration with ComNav server:
 Server: select SINOGNSS server(IP: 211.144.120.104 and Port:8888)
 BaseName: Click BaseName to get SN of Base receiver directly, when start
Rover, just select the name as source
 Differential mode: make sure to choose RTCM32
 Fix Position: Click Library choose to select a known point for the Base, or Get
from GNSS if you do not have a known point.
After successfully starting the Base station, the differential LED (yellow) flashes
once per second, which means the Base is broadcasting correction data;
Configure the Rover as below:
 Protocol: Select SINOGNSS directly;
 BaseName: Enter the SN of the Base receiver.