User's Guide

SinoGNSS
○
R
N5 User Guide
12
http://www.comnavtech.com/download.asp?bigclassid=28
2. Connect the receiver with your PC through 7-pin lemo to USB cable.
3. Turn on your N5 receiver and click set port in CRU -> USB in the serial port option
-> enter proper baud rate -> click Ok to complete receiver connection. The SN of
receiver will appear in the title bar if connected successfully.
Tips: two types of cable are provided in your package,
1) We recommend to use 7-pin Lemo to USB cable to configure the receiver and raw
observation data downloading;
2) With 7-pin Lemo to RS232 cable, you can connect N5 receiver with external power or
firmware upgrade.
4. Click Config to configure the receiver:
 Sample Interval: change the sample interval of observations, the maximum data
rate is 20 Hz, the minimum is one observation per minute.
 Mask angle: disable the receiver to track satellites that below the mask angle.
You can set mask angle values for different constellations, which can reduce
serious multipath influence or low SNR.
 Data Log: logging data manually or automatically.
 Data Log Session: 1) Manual means that the receiver keeps recording data in
one file until the receiver is turned off or its memory runs out; 2) if set to
1\2\3\4\12 hours, the data recorded will be saved into a file every 1\2\3\4\12
hours.