User's Guide

SinoGNSS
○
R
N5 User Guide
11
3.4 Receiver Web GUI interface
Step 1: Connect Wi-Fi of N5 receiver
Turn on the N5 GNSS receiver and wait for the N5 serial number to appear under
the available Wi-Fi networks on your smart phone or office computer.
For example, N5-0340XXXX (where xxxx represents the last four digits of the
receiver serial number).
Enter password: 12345678
Step 2: Login the Web
Select the receiver, open a web browser and then enter the following IP address:
http://192.168.1.1
Tip: Most web browsers for computers / laptops and smart phones / PDAs support the receiver
Web GUI
4 Static survey
This chapter describes static survey through N5 receiver and CRU software. For static
survey, you cannot change settings through front panel, you can configure it via
Compass Receiver Utility (CRU): 1) Receiver configuration; 2) check receiver settings
and status; 3) convert data to Rinex format.
4.1 Receiver Configuration
1. Download and install CRU software from the link below (ensure the driver is
properly installed in your PC):