User's Guide

SinoGNSS
○
R
N5 User Guide
9
2.5 Pole-mounted setup
To mount the receiver on a range pole as the figure shown below:
Tip: Do not tightly clamp the controller on the Range Pole.
3 General Operation
This chapter introduces all controls for the general operation, including OLED display,
button functions and all LED behaviors on the front panel.
3.1 OLED display
There are three interfaces on the OLED display, for let you know the status, work
mode of receiver and help you do some simple setting.
 Status interface:
Will show you the status of receiver. Including the solution status, satellite searching
condition, PDOP value and battery power.
 Work mode interface:
Will show you the work mode of receiver. Including protocol, frequency and Tx or Rx.
If the work mode is PDA Cors, there will no protocol, frequency and so on.
 Setting interface:
There will be some simple function settings, including smart base station, relay mode,
formatted memory, static data collection, WIFI control, language switching and
factory reset, etc.
Tip: Power button represents enter, and the raw data recording button controls you switch
function.
 Thread the receiver onto the range pole
 Mount the controller bracket to the pole
 Install the controller into the bracket