Owners manual
Tablet Suction Mount - Ver 1.0
Component List:
1 – Suction Cup
1 – Tablet Mount Holder
Do not obstruct your driving view in any way. Do not make adjustments to your device or this mount while you are driving.
How to Assemble the Window Suction Mount:
Step 1: After removing the components from the packing/carton, you will assemble the two pieces. Note there are 4 square
prongs on the circular flat piece that hangs from the suction mount. Line these prongs up with the 4 holes on the back of the
adjustable mount.
Step 2: There is a top/bottom to the mount. The see-through oval opening is the top. The Heininger logo is located at the top.
Once located, press (firmly) upward and the two components should “snap” into place.
Step 3: Locate the best position for the Suction Mount and be sure to remove the plastic sheet on the suction cup. Use the
round adjustment knob near the back of the suction cup to adjust the main viewing angle. Tighten when finished.
Step 4: Place the suction cup against the window and place your thumb on the “PRESS” button for leverage. With your other
hand, push the locking level in against the back of the suction cup until the Suction Cup is firmly secure. Do not obstruct your
driving view in any way.
Step 5: To install the tablet into this mount, depress the small button on the right side of the bracket that will hold the tablet in
place. Raise the single strut up (while depressing this button) above the height of the tablet and then insert the tablet, setting it
on the dual support struts on the bottom edge of the tablet. Bring the extended single strut down to the tablet and depress it
for a snug/firm grip on the tablet.
Step 6: To fine tune the display angle, adjust the knob on the back of the tablet mount. Tighten when finished.
Step 7: To remove the suction cup, simply retract the locking level on the back of the suction cup and use the extended flap on
the bottom of the suction cup to peel away.
Do not leave your tablet in the mount while the vehicle is parked to avoid the potential for vandalism and theft.
http://www.heininger.biz
Bellingham, Washington 98229 USA
Limited Liability, 90 Day Warranty Policy
Heininger Holdings, LLC, warrants the original owner of each new CommuteMate product against defects in workmanship and materials for 90 Day
from the date of purchase (at retail) of the product, provided it is purchased from an authorized CommuteMate product dealer. This Limited 90 Day Warranty is
not transferable and shall only apply to normal and ordinary use, for which the product was intended, as described in the Instructions provided.
Warranty claims are to be made directly to Heininger Holdings and must be accompanied by a sales receipt or other appropriate proof-of-purchase
document. Should this product or any part or accessory be determined by Heininger Holdings, to be defective and covered by this Limited 90 Day Warranty, it will
be repaired or replaced at the option of Heininger Holdings, without further charge. The cost of transportation to and from the referred warranty inspection facility
for repair or replacement of any defective part and/or accessory and any related charges is not covered by this warranty, and is to be paid by the owner.
The warranty does not cover normal wear and tear, worn and normal use cosmetic blemishes, improper assembly, lack of maintenance, or custom
alteration/installation of any parts or accessories not originally intended or compatible with the product as sold. The warranty does not apply to damage or failure
resulting from an accident, abuse or neglect.
This warranty is given in lieu of all other expressed warranties, implied warranties, including without limitation implied warranties of merchandising
ability and fitness for a particular purpose, and are limited to the duration and specification of this warranty. In no event shall Heininger Holdings, be liable for
damages in excess of the purchase price of the CommuteMate product, for any loss of use, loss of time, inconvenience, commercial loss, lost profits or savings or any
incidental, special, consequential, direct or indirect damages arising out of the use or inability to use such product, to the full extent as such may be disclaimed by the
law. Labor charges for part changeover are not covered by this warranty.