Owner`s manual

PAGE 42 Community Solutions™ Owner’s Manual
15 SERVICING
15.1 Servicing SLS Drivers
To service an SLS driver it must be removed from the enclosure. Refer to FIGURE 16 for details of not-
so-obvious procedures for the M200 and bottom bolts for the lower LF driver. Details will vary slightly
from model to model.
15.2 Servicing SBS Drivers
To service an SBS driver it must be removed from the enclosure. To do this, remove the grille (see
SECTION 11.3.1 “Removing/Installing the Grille”) and remove the retaining bolts around the
circumference of the driver. The driver can then be dismounted and serviced.
15.3 Servicing an SLS Input Panel and Crossover
To service an SLS crossover it must be removed from the enclosure. To do this, remove the 3/8” x 16
hex-socket screws from the rear panel. Disconnect the Molex connector that connects the driver
wiring harness to the crossover. The crossover may then be removed from the rear panel for service.
15.1 Servicing an SBS Input Panel
If for any reason an SBS input panel requires service, it must be accessed from the front of the
enclosure as the rear of the enclosure is NOT removable. To do this, remove the grille and one of the
drivers from the subwoofer. The input panel can then be removed as needed through the driver
mounting hole.
FIGURE 16: Servicing SLS Drivers
(Side view cut-away of SLS loudspeaker)