Owner`s manual

PAGE 30 Community Solutions™ Owner’s Manual
11.5.6 Stand and Mounting Bracket Inserts
The SLS915, SLS918 and SLS920 loudspeakers and the SBS12 subwoofer have 5/16-18 threaded T-nut
inserts on the bottom of the enclosures for mounting the loudspeakers on stands and for securing a
bracket to the enclosure for installation to a wall surface. The T-nut inserts are positioned and sized
to mate with an Ultimate Support stand mount (model MB-200), Omnimount brackets (see TABLE 6) or
similar hardware.
MODEL OMNIMOUN
T
SLS915 Use Series
100
SLS918 Use Series
300
SLS920 Use Series
300
SBS12 Use Series
300
Table 6: Omnimount Bracket Selection
CAUTION: The T-nut mounting points should be used ONLY for supporting the loudspeaker from
the bottom. Do not use for suspending the loudspeaker.
Because of their size and weight, all other Community Solutions models are not recommended for this
type of installation hardware and therefore they do not have provisions for them. Community cannot
provide specific technical support about the use of Ultimate Support or Omnimount Systems products.
For further information about their products see contact information in SECTION 5.16 “Optional
Accessories”.
FIGURE 12: Stand and Bracket Mounting Points