Owner`s manual

PAGE 24 Community Solutions™ Owner’s Manual
10.5.2 SLS BIAMPLIFIED Mode Operation (See FIGURE 5)
Operation of the SLS loudspeakers in BIAMPLIFIED mode requires putting the slide switch on the input
panel in the “Biamplified” (up) position. In this mode the LF and HF connections can be made using
either of the Neutrik Speakon connectors. Note that each Speakon connector can accept both the LF
and HF inputs. Alternately, the banana jacks can be used where the LF (low frequency) input
connections are made to the right dual banana jack and the HF (high frequency) input connections to
the left dual banana jack. In all cases, observe proper polarity when making the connections.
10.5.3 SBS Subwoofer
(See FIGURE 6)
The wiring connections for the SBS subwoofer are the same whether it is used in a stand-alone fashion
or configured with an SLS model in either PASSIVE or BIAMPLIFIED mode.
Make connections to the SBS subwoofer as shown in FIGURE 6 observing proper polarity.
FIGURE 5: Wiring for SLS in BIAMPLIFIED Mode
FIGURE 6: Wiring for SBS Subwoofers