Installation manual

Community S-Series - Operation and Installation Manual - Page 50
VFKIT Parts List
(1) Front Metal Bracket
(1) Rear Metal Bracket
(4) M10 30mm Bolts
(8) M10 Flat Washers
(8) M10 Split Lock Washer
(4) M10 Eyebolts
(4) M10 Hex Nuts
The installer must supply all other hardware for the installation.
VFKIT Assembly Instructions
1. First, remove the two factory supplied flat-head Allen screws on the inside tops of
each enclosure (4 total).
2. Assemble the components of the Vertical Fly Kit as shown in the drawing below. Attach
the Front Metal Bracket to the front of the enclosures using two M10 x 30mm bolts
fitted with lock washers and flat washers. At this time do not fully tighten the bolts.
3. Next, attach the Rear Metal Bracket to the rear of the enclosure, again using two M10 x
30mm bolts fitted with lock washers and flat washers.
4. Now, position the enclosures so that their rear corners are touching and lined up evenly
with each other. Tighten the bolts to a setting of 10 to 12 foot-lbs using a torque
wrench. Do not overtighten!
Figure 16: VFKIT Vertical Fly Kit Assembly
VFKIT Rigging Instructions
1. The Vertical Fly Kit should be rigged from both the front and rear points using
appropriate load-rated hardware. After rigging, lift the loudspeakers about two feet off
the ground. Carefully inspect the rigging to make sure that no shackles are twisted
and that all fasteners are tightened properly.