Specifications

Community R2-Series Installation/Operation Manual — Page 9
R2 QUICK START - FEATURES
Physical Features (See Figure 1)
PHYSICAL FEATURES OF THE R2
1
Top of enclosure is up for specified horizontal and vertical coverage.
6
MOUNTING/RIGGING POINTS DESCRIPTION
1
2
Mounting/Rigging Points
Five, one on each side and one on rear. 1/2"-13 captive zinc plated inserts with 1/2"-13 x
1" SS bolts and lock, flat and rubber washers. Used for attaching the R2 Mounting Yoke
or customer-supplied mounting system.
Other Mounting Points
3
Grille Retainers The grille assembly is retained by 16 #6 machine screws.
4
Mid-High Frequency Horn Mounts
Two on top and bottom of horn mount. 1/4-20 x 1" SS hex head bolts. Used to retain the
mid-high frequency horn assembly to the horn enclosure.
Input
5
Input Cable
For signal connections to the loudspeaker. About 12 ft of 16-2 SJOW retained by a
factory-sealed gland-nut. White = + and Black = -.
6
R2 Label
Model number, coverage pattern, serial number, hook-up, and power information. Also
used to identify the top of the horn enclosure.
7
Grille
Perforated steel backed by a layer of UV-resistant reticulated foam and a fine mesh
screen.
Other Features
8
Mid-High Frequency Horn Assembly Mounted inside bass horn to form a triaxial system.
9
Mounting Yoke The mounting yoke is included. See Figure 4A and 4B for assembly instructions.