Specifications

Community R2-Series Installation/Operation Manual — Page 20
MAINTAINING WEATHER-RESISTANCE
There are several things that must be observed when installing an R2 in order to maintain its weather-resistant
integrity for outdoor use.
1. We recommend angling the R-Series loudspeaker at least 15 degrees downward
so as to reduce the
possibility of rain and other precipitation compromising the performance of the loudspeaker.
2. All five mounting holes must be sealed off with the stainless steel bolts, washers, and rubber washers
supplied. If, for any reason, these bolts must be removed, seal off the hole with silicone caulking or some
other suitable weather-tight sealant.
3. The rubber washers supplied with the mounting bolts must always seat against the enclosure.
4. The gland-nut securing the loudspeaker cable to the enclosure is sealed at the factory. Do not attempt to
remove this nut or the weather-tight seal will be broken. If it is desired to replace the gland-nut with a jack,
the jack must be a weather-proof design. It must be suitably sealed to the enclosure with silicone caulk or
some other suitable weather-tight sealant. The Neutrik model NL4MP is an excellent connector for this
purpose. The gland-nut should be at the bottom when mounting. Leave a “drip loop” so water will
not migrate toward the loudspeaker.
5. The grille assembly is designed to prevent normal and wind-driven rain from directly entering the mouth of
the loudspeaker. The grille is not designed to withstand such things as being directly sprayed from a hose;
therefore, this should be avoided.
6. If you use any hardware in place of the stainless steel screws, bolts, nuts, and washers supplied, it should
also be made of stainless steel.
CAUTION: If the above instructions are not observed, the weather-resistant integrity of an R2 can be
compromised. This can result in damage to or failure of the hardware or internal components which will
void the warranty.
MECHANICAL INSTALLATION AND SAFETY
DANGER: The loudspeakers described in this manual are designed and intended to be ‘flown’ or
suspended for maximum acoustical performance using a variety of rigging hardware, means, and
methods. It is essential that all installation work involving the suspension of these loudspeaker products
be performed by competent, knowledgeable persons who understand safe rigging practices. Severe
injury and/or loss of life may occur if these products are improperly installed.
Important Notes on Rigging Loudspeakers
There are three areas of responsibility for rigging loudspeakers. The first is the building structure. Always
consult with the building architect or structural engineer to assure the ability of the structure to support the
loudspeaker system. The second area of responsibility is the loudspeaker itself. Community certifies its
loudspeaker systems for suspension when they are properly installed according to our published guidelines.
The third area of responsibility is everything between the loudspeaker and the building structure and the actual
process of installation. The installing contractor assumes this responsibility. Loudspeaker rigging should be
performed only by certified rigging professionals using certified rigging hardware chosen for the
specific application. Prior to installation, the contractor should present a rigging plan, with drawing and
detailed parts list, to a licensed structural engineer (P.E.) or architect for written approval.
PHYSICAL / MECHANICAL INSTALLATION