Specifications

Community R2-Series Installation/Operation Manual — Page 18
R2 MOUNTING YOKE PARTS LIST
(1) Yoke Bracket
(1) Aluminum Contour Strap
(1) Aluminum Securing Strap
(3) 1/2-13 x 2” (50 mm) stainless steel bolts
(1) 1/2-13 stainless steel hex nut
(2) 1/2" stainless steel flat washers
(1) 1/2" stainless steel lock washer
(1) 1/4-20 x 1" (25 mm) stainless steel bolt
(2) 1/4-20 stainless steel hex nuts
(2) 1/4" stainless steel flat washers
(2) 1/4" stainless steel lock washers
All other hardware must be supplied by the installer.
R2 MOUNTING YOKE ASSEMBLY INSTRUCTIONS
(SEE FIGURE 4A AND FIGURE 4B)
Normally the yoke should first be attached to the R2 then the entire assembly mounted to a structure. However
in some unusual cases it may be desirable to mount the yoke and secure it in place before mounting the R2 to
the yoke. Depending on the situation the sequence of the following mounting procedure may have to be modified
to facilitate the work. Nonetheless the instructions and precautions about use of the hardware should still be
followed.
1. To attach the yoke to the R2, first determine whether the yoke will be attached to the sides or top/bottom of
the loudspeaker. This will depend on what the yoke is to be mounted to and how the R2 must be oriented when
positioned for proper coverage (See “Orienting an R2”, page 16 ).
2. Once the position of the yoke is determined, remove two supplied 1/2-13 stainless steel mounting bolts, with
the lock, flat, and rubber washers from the mounting points where the yoke is to be attached.
FIGURE 4B
PHYSICAL INSTALLATION