Specifications

Community R2-Series Installation/Operation Manual — Page 17
INSTALLING THE R2 MOUNTING YOKE
CAUTION: The R2 Mounting Yoke is specifically designed to provide a high degree of safety in R2
installations. It is highly recommended for mounting an R2. Other mounting methods should be carefully
considered so that undue strain and possible failure of the mounting points does not occur.
CAUTION: In order to maintain the weather-resistant integrity of an R2, all five rubber washers supplied
with the R2 mounting point hardware must be used and be flush against the enclosure when the R2 is
mounted.
The yoke has three 17/32” (13.5 mm) holes in the crossbar. These holes are intended for attachment of the yoke
to the structure to which the R2 is to be mounted. The hardware used for the attachment must be load-rated for
the intended purpose. Also ensure that the structure you are attaching to is capable of supporting the
loudspeaker and yoke assembly. This must include any torque load that may be applied to the structure as a
result of the loudspeaker/yoke position and aiming angle. For outdoor installations wind loading must also be
taken into account. It is recommended that a qualified and licensed structural engineer approve the mounting
design.
PHYSICAL INSTALLATION
Figure 4A