Installation manual

Community WET Series II - Operation and Installation Manual - Page 21
INSTALLATION CONSIDERATIONS
Installing WET Series II loudspeakers is simple and straightforward. In most cases they will simply be affixed to
a wall or ceiling surface by means of the stainless steel yoke-style mounting bracket that accompanies the four
smaller models, and is available as an optional accessory to the larger models. Always pay close attention to
the type of fasteners used, the nature of the mounting surface(s), and the suitability of the mounting method.
CAUTION! If there is any doubt as to the structural integrity of the mounting surface(s) and/or the
nature and use of the fasteners or other mounting materials, means, or method(s), consult a licensed
professional engineer who can provide accurate information that will assure a safe and reliable
installation. The potential for injury and/or death resulting from improper installation practices and/or
inadequate materials is very high. Please read the section on Safe Rigging Practices for additional
information, found elsewhere in this manual.
C-TIP: When installing WET Series II loudspeakers, particularly the larger models, it is helpful to wear a
pair of heavy-duty industrial grade rubber gloves. The glass surface material and the unique curved
shape of the enclosures can otherwise be difficult to handle.
Installing with Yokes
When attaching a yoke bracket to a WET Series II loudspeaker, always make sure to use the rubber washers
(supplied). They are intended to be placed between the yoke and the loudspeaker enclosure. They provide a
seal to inhibit the penetration of water into the enclosure, as well as increase the friction between the enclosure
and the yoke assembly. The bolts should be fitted with a lock washer and a flat washer (supplied), and
tightened to a torque of approximately 8 to 12 foot lbs. Be cautious, as overtightening can cause deformation
or damage to the fiberglass enclosure. Use a torque wrench!
IMPORTANT! Make sure that all rigging and mounting fittings have bolts, lock washers, flat washers
and rubber washers installed before completing the installation. No rigging or mounting fitting should be
left open to the elements.