Specifications

Community R-Series Installation/Operation Manual for Models R.5 and R.25 — Page 26
I M P O R TAN T I N S TAL L AT I O N N O TES
Mounting Hardware Notes
When tightening mounting point hardware, do not use excessive force. Any bolts used in place of the supplied
mounting studs should be properly rated stainless steel and should not extend into the hole more than 3/8" (9.5
mm). Ensure that the hardware used to attach the yoke (or other mounting hardware) to the supporting structure
and that the supporting structure itself are load rated for the intended use and suitably weather resistant.
Notes on Weather-Resistance
No loudspeaker is completely “weather proof”. However, Community R-Series loudspeakers are designed to with-
stand continuous outdoor exposure for many years of operation. Community R.5 Series have an IP (International
Protection) rating of IP51 in accordance with guidelines set forth under BS EN 60529:1992 by the Electrical
Installation Equipment Manufacturers’ Association (EIEMA).
We recommend angling the R.5 or R.25 loudspeaker at least 15 degrees downward so as to reduce the pos-
sibility of rain and other precipitation compromising the performance of the loudspeaker. The R.5 or R.25
will maintain an EIEMA rating of IP51 in this orientation.
All five mounting holes must be sealed off with the stainless steel bolts, washers, and rubber washers supplied. If,
for any reason, these bolts must be removed, seal off the hole with silicone caulking or some other suitable weather
-tight sealant. The rubber washers supplied with the mounting bolts must always seat against the enclosure.
The gland nut securing the loudspeaker cable to the enclosure is sealed at the factory. Do not attempt to remove
this nut or the weather-tight seal will be broken. If it is desired to replace the gland nut with a connector, the
connector must be a weather-proof design. It must be suitably sealed to the enclosure with silicone caulk or some
other suitable weather-tight sealant. The Neutrik model NLT4MP is an excellent connector for this purpose.
The grille assembly is designed to prevent normal and wind-driven rain from directly entering the mouth of the
loudspeaker. The grille is not designed to withstand such things as being directly sprayed from a hose; therefore
this should be avoided.
If you use any hardware in place of the stainless steel screws, bolts, nuts, and washers supplied, it should also be
made of stainless steel. Community recommends periodic inspections of installed rigging hardware to discover and
repair any unexpected corrosion or damage.
Always use outdoor-rated cable. Always seal connections in a weather-tight electrical box.
IMPORTANT: If the above instructions are not observed, the weather-resistant integrity of an R-Series
loudspeaker can be compromised. This can result in damage to or failure of the hardware or internal
components.
F I E L D S E RV I C E
Any driver or crossover service required is done from the front of the enclosure by removing the screws around
the edge of the grille. For warranty repair, contact Community directly or ask us for the location of your nearest
Authorized Service Center.
INSTALLATION