Specifications

Distributed Design Series Installation and Operation Manual Page 7
Surface Mount Loudspeakers
Installation and Wiring
1. Connect incoming input wires (and
optional loop-thru wires) from wall
to 4-pole Euroblock screw terminals
concealed in the base of the Inn-A-Ball
bracket.*
Input Wires
(not included)
Loop-Thru Wires
(optional)
2. Secure the Inn-A-Ball bracket to the wall
using your screws or other fasteners according
to local building and safety codes.
Terminal Block
Inn-A-Ball bracket
*Note: Check local codes
to determine if a wall box
or metal plate is required
for the integrated wiring.
See page 10.
3. Insert the hex wrench into the socket near
the rear of the loudspeaker cabinet, and turn
counterclockwise to loosen the clamp setscrew.
4. Fit the cabinet onto the IAB bracket’s ball-
end, then tighten the clamp sufciently to
hold the loudspeaker in place, but allowing for
positional adjustment.
Loosen Tighten