Specifications

Distributed Design Series Installation and Operation Manual Page 6
Surface Mount Loudspeakers
Community’s Inn-A-Ball™ (IAB) mounting
system allows low-prole mounting and precise
aiming over a broad tilt–swivel range. The IAB
ball-mount receptacle is factory pre-attached to
a recess in the cabinet, and after placing the
loudspeaker onto the IAB bracket, you need
only to twist the included hex wrench to lock any
position. The IAB bracket has factory-installed
internal wiring with an internal 4-pole Euroblock
connector in its base (for neat loop-through
connections) and a 2-pole male Euroblock plug
near the ball end for connection to the cabinet.
An IP56 wiring cover is also pre-installed,
providing snap-on weather-resistant protection.
Inn-A-Ball™ Mounting System
Loosen clamp using provided hex wrench,
rotate loudspeaker cabinet to desired position,
then tighten clamp to lock
Actual clamping screw
pressed against ball end
of IAB bracket.