Specifications

Community Distributed Design Series Installation and Operation Manual Page 7
Unpacking and Inspection
Community Distributed Design loudspeakers
are engineered and manufactured to be rugged
and they are carefully packed in sturdy cartons.
However, it is wise to thoroughly inspect each unit
after it has been removed from the packaging, as
damage could occur during shipping.
Please note that once the shipment has left your
dealer or the Community factory, the responsibility
for damage is always borne by the freight company.
If damage has occurred during shipping, you must
leaclaimdirectlywiththefreightcompany.It’s
very important to contact the freight company as
soon as possible after receiving your shipment,
as most freight companies have a short time limit
within which they will investigate claims. Make
sure to save the carton and the packing material,
as most claims will be denied if these materials
are not retained. Your Community dealer and the
factory will try to help in any way they can, but
it is the responsibility of the party receiving the
shipmenttolethedamageclaim.
It’s always a good idea to retain the carton and
packing materials indenitely, if possible, in the
event that the unit may need to be returned to
your dealer or distributor for repair in the future.
For each of the seven models in the Distributed
Design Series, it is possible to order a full Ceiling
Loudspeaker Assembly, a Face-Only Assembly
or a Back Can Assembly. Consult the three lists
(beginningonthenextpage)tondthecontents
of each carton for the version of the assembly you
have ordered.
This document conrms that the range
of products of Community Professional
Loudspeakers bearing the CE label meet
all of the requirements in the EMC directive
89/336/EEC laid down by the Member States
Council for adjustment of legal requirements.
Furthermore, the products comply with the rules
and regulations referring to the electromagnetic
compatibility of devices from 30-August-1995.
The Community Professional Loudspeaker
products bearing the CE label comply with the
following harmonized or national standards:
DIN EN 55013:08-1991
DIN EN 55020:05-1995
DIN EN 55082-1:03-1993
The authorized declaration and compatibility
certicationresideswiththemanufacturerand
can be viewed upon request. The responsible
manufacturer is the company:
Community Professional Loudspeakers
333 East Fifth Street
Chester, PA 19013-4511
USA
TEL: [phone]
FAX: [phone]
Chester, PA USA December, 2013
EC Statement of Conformity