Specifications

Community Distributed Design Series Installation and Operation Manual Page 29
4. Once the loudspeaker is secured in
the back can, you can attach the safety
cable between the grille and loudspeaker.
There is a nylon mono lament loop
attached to the grille and looped through
ametalclip.Anothermonolamentlineis
locatedinsidethebassreexportofthe
face of the loudspeaker. Use the metal
cliptolinkthesetwomonolamentloops.
See Figure 33.
Figure 33. Grille safety clip and line (left) should look like this (right) when attached.
5. Carefully lower the grille until the cable holds
it, and let go. It should hang harmlessly from the
monolamentline.
6. If you’re proceeding with setup, you can leave
the grille hanging so you can adjust the power
setting as noted on the next page. Otherwise,
snap the grille into position on the face of the
loudspeakerbafe.