Specifications

Community Distributed Design Series Installation and Operation Manual Page 25
Figure 28. New installation in an existing
drywall ceiling
Use the Tile Bridge Support Rails
and C-Ring Support Plate.
C. Retrot a Distributed Series Loudspeaker
(driver/face plate without back can) into an existing
back can using a corresponding Distributed
Series Face Adapter Ring.
D. Retrot an entire Community Distributed
Series Loudspeaker Assembly (including
back can) into an existing back can using a
corresponding Distributed Series Can Adapter
Ring.
Note: If you are retrotting a new loudspeaker alone,
without back can, into an existing low-prole back can
for a 4.5" competitor’s model (minimum 3.5" / 89 mm
deep), you can use the D4-FO loudspeaker alone, but
if you wish to drop an entire Loudspeaker Assembly into
an existing 4.5" can, use the D4LP (with Can Adapter/
Trim Ring). While the latter includes a shallow back can,
both the D4 and D4LP use the same D4-FO loudspeaker
which has a shallow depth.
Note: We do not offer a Face Adapter Ring for our larger
model loudspeakers.
Dry-Wall Ceiling Installation
There are four basic ways to install a Community
Distributed Series loudspeaker assembly into
a drywall ceiling (a.k.a. sheet rock or gypsum
board).
Some are for new construction, others for
retrot to existing construction. We recommend
some methods over others and of course the
choice is yours.
A. The preferred method for new
installations is to use the optional New
Construction Bracket, pre-installing it directly to
the supporting beams before the sheet rock is
applied. Multiple small holes on wings to either
side of the main cutout hole allow the installer
to use screws or nails to secure the ring to the
straddling beams. See the following subsection
for step-by-step details and variations.
B. An alternative method for new
installations – where the ceiling has already
been completed – is to use the C-Ring Support
Plate along with the Tile Bridge Support Rails.
While there are in fact not going to be truss
membersacrosswhich therailst,nonetheless
they will distribute the weight of the loudspeaker
assembly across a greater area than the C-Ring
Adapter alone and will thus avoid sagging that
might otherwise occur over time. You can cut the
hole using the provided template or using a New
Construction Bracket as a cutting guide, even
though this bracket won’t be used for anything
else. It’s then easy to pass the Tile Bridge Support
Rails through the cutout and snap the C-Ring
Support Plate on top of them. Refer to Figure 25
on page 23 and to Figure 28.