Specifications

Community Distributed Design Series Installation and Operation Manual Page 18
Component Identication
Internal leads and plug to bring rear terminal
block signal to the loudspeaker’s input
connector on the circuit board
Figure 18. Component part identication (1)
Twist-Assist™ can
mating clip (4)
Zinc plated steel
can-locking
clamp (4)
Dog screw alignment slot
(4 typical). Used to align
face in proper location
when installing back can
Bass reex port
Hole for 4mm sheet
metal screw (4 typical)
Loudspeaker
input connector
on circuit board
Phillips-head can-locking
clamp actuator (4)
Twist-Assist™
face mounting
clip (4)
Combination terminal block cover and
cable strain relief clamp
Input terminal block
3/4" and 1"
knockout
strain relief
Knockout strain relief on
terminal block cover (with
conduit installed)
Steel can-locking clamp
(shown deployed)
Zinc plated steel
can-locking
clamp (4)
Drop-Stop™ tab (4)