Operating instructions

Community CLOUD12 – Operation Manual - Page 23
Eyebolt Suspension:
The eyebolts must be screwed in so that the shoulder firmly contacts the surface of the enclosure. In all
cases the direction of pull on the eyebolt and mounting point should not exceed a maximum of 45º from the
vertical axis of the mounting point hole. Multiple cables that can independently support the loudspeaker
must also be used. See the following figure.
NOTES:
 There is no benefit in tightening the eyebolt more than hand tight. Never pull an eyebolt sideways
or at 90° to a vertical pull angle.
 The CLOUD12 family of loudspeaker assemblies must be installed in a backbox prior to permanent
installation. In order to conform to local electrical codes, do not install any CLOUD12 loudspeaker
assembly in a ceiling without an appropriate backbox such as the Community C12BB3.
 The CLOUD12 loudspeakers can generate substantial vibrations, which can cause the ceiling tile or
other parts of the support structure to audibly buzz. Depending on the nature of the ceiling tile and
the overall structure, the installer may elect to adhere dampening material (not provided) such as
neoprene under the tile rails or the edges of the tiles themselves to eliminate buzzing or rattling.
Figure 23: “Snugging” the ¼-inch eyebolts
Figure 24: Eyebolt load ratings