Installation guide

CLOUD 4 and CLOUD 6 – Installation Guide
6
INSTALLATION AND WIRING
Connect the end of the wiring to the removable
locking connector that is included with the
speaker by stripping the insulation back about
5mm (1/5 inch), inserting the bare end of the
wire into the connector and screwing down the
hold-down screw until tight. Tighten any
unused screws to avoid vibration.
Figure 7-Attaching wires to connector
Step 4 Attach Wiring to the Removable Locking Connector
CAUTION:
ALWAYS USE THE
PROPER FITTING IN
ACCORDANCE WITH
YOUR AREA’S
BUILDING CODES
A
ND REGULATIONS
Using an Alternate Fitting – the existing strain relief
fitting accommodates many common fitting requirements.
Sometimes, alternate fittings are required, such as for
larger diameter conduit or to meet specific code
requirements.
In these cases, the existing fitting can be easily replaced
with a number of available off-the-shelf fittings. Simply
remove the existing fitting by unscrewing the two hold-
down screws, exposing a 7/8 inch (22mm) knockout hole.
Then, install the alternate fitting.