Operating instructions

Community Commercial Design Series Installation and Operation Manual Page 7
The Can Adapter Ring can be used as a Trim
Ring, allowing you to mount a Commercial
Design loudspeaker assembly into an existing
but over-size ceiling cutout hole. When
used as a trim ring, white rubber hole plugs
(included) ill the 4 countersink indents.
A New Construction Bracket is available for
installing loudspeakers in new construction
before drywall or plaster is put in place. The
drywall typically is cut with a router-type
tool or laser guided cutter in which case the
bracket hole will serve as a cutout guide.
Optional Accessories
Community offers helpful optional acces-
sories that are not included with the basic
packages. Please be sure to order these parts
separately if you need them.
Can Adapter Trim Rings allow you to mount
an entire Commercial Design loudspeaker
assembly into an existing industry back
can that is already in the ceiling from a
previous installation. If you’re performing
a retroit, you will want to order the type of
adapter you need in the size suitable for the
loudspeaker.
Can Adapter/Trim Ring
Ca
n
Ad
ap
te
r/Trim Rin
New
Construction
Bracket
on
Full Ceiling Loudspeaker Assembly (Typical)
(Models: C4LP, C4, C6, C6-B and C8)
• Ceiling Loudspeaker Assembly (Qty 2)
• Tile Support Bridge Rails (Qty 4)
• Bridge Rail Spacers (Qty 4)
Paint Masks
Loudspeakers
(with integral back cans)
• Grilles (Qty 2)
• Cut-out template (can-sized) (Qty 1)
• Paint Masks (Qty 2)
• Flat screwdriver (Qty 1) (for screws,
connectors and to help remove the grille)
Grilles
Grilles
Cut-out Template
Flat
screwdriver
Support Bridge
Rail Spacers
Support B
r
R
ai
l
Spa
c
Figure 1. Full Ceiling Loudspeaker Assembly Package Contents (typical)
Tile Support
Bridge Rails
T
ile S
up
po
r
t
B
rid
g
e Rail
s
Note: Some models share a common accessory
item, as indicated in the chart.
Figure 2. Optional Accessories