Operating instructions
Community Commercial Design Series Installation and Operation Manual Page 19
Note: Some codes now require that
the grille have a safety cable; your
local codes may vary. Community
makes it easy to comply with an
included security cable system, as
detailed in Steps 1 through 3 below.
1. Once the loudspeaker is secured in the
ceiling, you can attach the safety cable be-
tween the grille and loudspeaker. There is
a nylon mono ilament loop attached to the
grille and looped through a metal clip. An-
other mono ilament line is located inside the
Figure 19. Grille Safety Clip and Line (left) Should Look Like This (right) When Attached.
bass relex port of the face of the loudspeaker.
Use the metal clip to link these two mono ila-
ment loops. See Figure 18.
2. Carefully lower the grille until the cable
holds it, and let go. It should hang harmlessly
from the mono ilament line.
3. If you’re proceeding with setup, you can
leave the grille hanging so you can adjust the
power setting as noted on the next page. Oth-
erwise, install the grille into position on the
face of the loudspeaker bafle.
Safety Cabling The Grille