Operating instructions

Community Commercial Design Series Installation and Operation Manual Page 14
4. Locate the two Phillips-head actuators
around the perimeter of the loudspeaker’s
front lange (see Figure 14). Using a #2 Phil-
lips screwdriver twist each actuator clock-
wise until you feel resistance as the clamps
press against the ceiling bridge rails (Fig. 15).
Figure 14. Turning the two loudspeaker
clamp actuators clockwise securely locks
the unit into the ceiling.
Figure 15. Mounting Clamps Shown Grip-
ping Tile Support Bridge Rails After the
Clamp Actuators Have Been Tightened.
designed to drop into the Tile Bridge support
rails channels, they will not work properly if
mis-aligned. See note and Figures 12 and 13
on the next page.
Note: If you’re using loose wires, rather than
conduit, ϔirst connect the wires to the termi-
nal block atop the loudspeaker assembly, and
secure them with the top cover/strain relief,
before installing the can through the cutout
and into place.
Figure 12. Position of Loudspeaker Relative
to Bridge Support Rails During Installation
Figure 13. Drop-Stop Tabs (highlighted)
Snap Out Over Bridge Support Rails
(Temporarily holds unit in place even before
you secure it with the mounting clamps)