Operating instructions
Community Commercial Design Series Installation and Operation Manual Page 12
3. Insert appropriate ittings and tighten
suficiently for wire path concealment and
strain relief, in accordance with applicable
codes.
Figure 9. Conduit for Protected Wiring to Can
Conduit ϐitted to the top cover plate of the can,
which has a knockout strain relief for this
purpose.
Figure 8. Non-Conduit Guided Wiring to Can and Wire Restraint
(Only use this method when permitted by applicable building and electrical codes!)
Terminal Block (6” model)
Terminal Block showing wire
connections to the block for a
single cable (not daisy-chained)
Built-in cable strain relief
Cover/strain relief plate
swiveled into closed position
and secured to clamp the
cable ϐirmly. Note the 3/4
inch (19 mm) knockout in
the cover that may be used
for conduit.
4. You can use lexible or rigid conduit (as
required by local electrical codes).