Installation guide

Meikai ENERGY
Page 5 Copyright MeiKai ENERGY 2012 REV 1.0
Installation and Operation Instructions
Important Safety Instructions
This manual contains important instructions for equipment installation and maintenance. For your own
safety, please follow the safety instructions during the installation and maintenance. Please pay
attention of the following safety symbols:
WARNING：This indicates a situation where failure to follow instructions may cause
personnel danger or serious hardware failure. Use extreme caution when performing this
task.
NOTE: This indicates information particularly important for optimal operation. Follow
these instructions closely.
Safety Information
WARNING: the Meikai Micro-inverter dissipates heat through its case, the temperature
may 15 °C higher than ambient temperature. DO NOT touch the device surface when
device is running to avoid burns. Handle the device with caution.
 The installation of inverter must be performed in full compliance with the National Wiring Rules of
Standard AS/NZS 3000 and other relative local standards and regulations.
 Be aware that only qualified personnel are allowed to maintain Meikai Micro-inverters.
 DO NOT attempt to repair the Meikai Micro-inverter, it is unrepairable. If it fails, please return
the unit to your distributor or Meikai Customer Service for maintenance. Tampering with or
opening the Meikai Micro-inverter will void the warranty.
 Before installing and operating Meikai Micro-inverter, please read all instructions for the
inverter and the module. Be aware of the WARNINGs appear in the technical description.
 Connect the Meikai Micro-inverter to the local electricity utility grid only after receiving prior
approval from the utility company. Meikai takes none responsibility for any on-grid system
without such approval.
 DO NOT disconnect the PV module from the Meikai Micro-inverter without disconnecting AC
power.