Installation guide

Meikai ENERGY
Page 10 Copyright MeiKai ENERGY 2012 REV 1.0
Step 2- Attach Meikai Micro-inverter to the racking
A. Determine the location with respect to the PV module junction box or any other obstructions.
WARNING: Allow a minimum of 15cm between the top of the roof and the bottom of the
Micro-inverter. We also recommend that you allow 5cm between the back of the PV
module and the top of the inverter. DO NOT mount the micro-inverter in a location that
allows exposure to direct sunlight.
B. If a grounding washer is used to connect the micro-inverter to the racking, please make sure
use only ground washer that is approved by the racking manufacturer. Use a minimum of one
grounding washer per micro-inverter.
C. Mount one micro-inverter at each of these locations using hardware recommended by your
module racking supplier.
Step 3-Connect the Meikai micro-inverter to the AC branch cable
Each micro-inverter comes with a 15cm AC wire with one 3 pin female connector and a 156cm AC wire
with one 3 pin male connector. As indicated in the following picture: