User's Manual

3
Safety and Regulatory Information
Read all of the instructions listed here and/or in the user manual before you operate this device. Give
particular attention to all safety precautions. Retain the instructions for future reference.
This device must be installed and used in strict accordance with the manufacturer’s instructions, as
described in the user documentation that is included with the device.
Comply with all warning and caution statements in the instructions. Observe all warning and caution symbols
that are affixed to this device.
Installation of this device must be in accordance with national wiring codes and conform to local regulations.
Do not overload outlets or extension cords, as this can lead to risk of fire or electric shock. Overloaded AC
outlets, extension cords, frayed power cords, damaged or cracked wire insulation, and broken plugs are
dangerous. They may result in a shock or fire hazard.
Do not open the device. Do not perform any servicing other than that contained in the installation and
troubleshooting instructions. Refer all servicing to qualified service personnel.
This device should not be used in an environment that exceeds _______.
FCC Statements
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential environment. This equipment generates uses and can radiate radio frequency
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. Potential harmful interference to radio or television reception can be determined by turning the
device off and on. If this equipment does cause such interference, the user is encouraged to make attempts
to correct the interference by taking one or more of the following measures:
● Reorient or relocate the receiving antenna
● Increase the separation between the device and receiver
● Consult the dealer or an experienced radio/TV technician for help
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC CAUTION: Any changes or modifications not expressly approved by Motorola for compliance could
void the user’s authority to operate the equipment.