User's Manual

850 Band 1W Small Cell Amplifier User Guide Page 2
Communication Components Inc.
89 Leuning Street
South Hackensack, NJ 07606
Phone: [phone]
Fax: [phone]
www.cciproducts.com
Figure 1 - “Typical Site Installation Config.” Block Diagram for AWS 80W Cell Extender
Setting the RF Output Power to the SCB-850-1W-ALU-OD-1 MetroCell Amplifier:
The RF output power is not adjustable on the UMTS850 Band Amplifier. The user must adjust the RF
input power to the SCB-850-1W-ALU-D-1 such that the RF output power level does not exceed the levels
shown below in order for the RF output spectral emissions to be compliant with the FCC spurious
emissions limit of -13 dBm outside of the assigned frequency block. These levels must not be
exceeded. The total output power at the TX/RX terminal of the device must not exceed the peak
output power of 1W.
*Note: The Maximum RF Output Power is after any passive losses after the Small Cell Amplifier Module
such as filters and cables.
This equipment complies with Part 22 of the FCC rules. Any changes or modifications not expressly
approved by the manufacturer could void the user’s authority to operate the equipment.
In order to comply with FCC rules for RF exposure, it must be observed that the antenna connected to
this equipment be fixed on an outdoor structure and that it must have a minimum separation distance of
10 meters between it and any person.
CCI does not provide antennas, cables and/or coupling devices for this product. Only antennas, cables
and/or coupling devices which are authorized by ALU (Alcatel-Lucent) should be utilized with this UMTS
850 Band MetroCell Amplifier.
Center Channel
Frequency (MHz)
Maximum RF
Output (Watt)*
869 - 894
1